How To Use Drywall Anchors With Wings

Drill a hole in the wall the same width as the butterfly drywall anchor.

How to use drywall anchors with wings. Plasterboard wall anchors i discovered these p. Picture a long screw with two perpendicular wings at the end just like this one link to amazon. Use a drill bit that s the same size as the dry wall anchor. You will drill a hole in the drywall that s just big enough for the wings to pass through while pressed down parallel to the screw. Remove the wing or butterfly piece from the screw or bolt that came with it.

These wings can be pressed down so that they are parallel to the screw. If you don t have an electric drill press the tip of a philips head screwdriver against the wall and twist it back and forth to create a hole. Pull the plastic taut until it is flush with the wall. As with the expansion anchor drive it in until it sits flush with the drywall. You need to fold back the wings and then insert the unit into the wall and it will then spread back out to create a sturdy hold.

The wings are pulled firmly against the wall after the screw is installed. Once the anchor is in place a wand included with the anchor is pushed through the hole to expand the wings on the backside. Use a 1 2 inch pilot bit to drill a hole into the wall. The metal sleeves utilize two spring loaded wings that open inside the wall. Plastic anchors should be installed carefully to prevent them from being damaged.

Butterfly anchors are a classic type and they re arguably the strongest type of drywall anchors. To use dry wall anchors start by drilling a hole into the wall you re installing the anchors in at a 90 degree angle. Slide the bracket or object you wish to secure. Pull the plastic to make sure that the metal is pulled tight against the back of the drywall. The anchor won t function properly unless this is done even though it might feel strong when it s screwed in.

They can hold between 25 and 35 pounds each when used in drywall. Insert the metal portion into the hole.