How To Install Drywall Expansion Anchor

Tap the head of the anchor lightly with the hammer until it is flush with the wall.

How to install drywall expansion anchor. Once you have your pilot hole in place you can use it to install any type of drywall anchor. Use drywall anchors follow these four simple steps to give whatever you re hanging to the wall a towel rack photo ledge or gilded mirror a little extra support. Do not bang on the screw because it could bend or break. Make sure the holes are not too small because this may cause the anchor to collapse onto itself. If the hole is too small the anchor will collapse onto itself and may not install properly.

Push it in until the anchor sits flush against the wall. In case you need to you can always tap the anchor with a rubber mallet to get it to sit flush on the wall. In any case to use an expansion anchor start by drilling a hole in the drywall that s roughly the same diameter as the anchor. This is where you ll find out of the hole you drilled is either too big or too small. Insert the single expansion anchor into the hole and tap the fastener lightly with a hammer to ensure it is flush with the base material.

Slide the expansion anchor into the hole. Drill straight into the drywall at a precise 90 degree angle. After that gently hammer the anchor into the wall. Hold the drill bit perpendicularly against the wall and keep a steady hand to ensure that the hole is as straight as possible. If the fit it too tight the anchor will bend or break and you will have to start over with a new one.

Slide the anchor into the hole push the anchor until it seats flush on the wall.